MAINTENANCE CHECKLIST

Maintenance Checklist
Heat Pump and Central Air Conditioning Tune-up, Cleaning and Safety Inspection
Tune-up your air-conditioner and insure your systems reliability!

Our trained technicians will perform a precision tune-up and professional cleaning including the following 16 operations:
1. Blower Motor – measure amperage and voltage for proper operation
2. Thermostat – test for proper operation, calibrate and level
3. Replace existing air filter (as needed)
4. Bearing – inspect for wear and lubricate
5. Condensate Drain – flush and clear restrictions
6. Inspect Condenser Coil
7. Refrigerant – monitor operating pressures
8. Safety Devices – inspect for proper operation
9. Electrical Wiring – inspect and tighten connections
10. Test/inspect contactors for burned, pitted contacts
11. Inspect electrical for exposed wiring
12. Inspect and test capacitors
13. Inspect fan blade
14. Inspect service valves for proper operation
15. Measure Supply/Return temperature differential
16. Compressor – monitor, measure amperage and volt draw and wiring connections

Furnace and Boiler Tune-Up, Cleaning and Safety Inspection
Keep Your Furnace or Boiler System at Peak Efficiency with an Annual Tune-Up – and Safeguard your Family. Tune-up your system and ensure your systems reliability.

Our trained technicians will perform a precision tune-up and professional cleaning including the following 16 operations:
1. Thermostat – test for proper operation, calibrate and level
2. Inspect for combustible material around furnace
3. Ignition System – test for safe and proper operation
4. Exhaust System – test for proper venting
5. Measure Supply/Return temperature differential
6. Safety & Control Circuits – test for proper operation
7. Inspect and adjust fan belt tension (if applicable)
8. Replace existing air filter(as needed)
9. Lubricate and clean blower motor
10. Furnace Burner – clean and inspect (brush and vacuum)
11. Heat Exchangers – clean and inspect (brush and vacuum)
12. Gas Pressure – measure and adjust for peak efficiency
13. Lubricate all moving parts per manufacture
14. Blower Motor – measure amperage and voltage for proper operation
15. Electrical Wiring – inspect and tighten connections
16. Natural Gas – check for leaks
Share by: